ADVERTISEMENT | ADVERTISE WITH US

TLR 22 4.0 and 22T 3.0 rear bumper mod explained by JR Mitch

ADVERTISEMENT | ADVERTISE WITH US

0 Sept. 7, 2017, 9:29 a.m.

Main Photo: TLR 22 4.0 and 22T 3.0 rear bumper mod explained by JR Mitch

By Mike Garrison
LiveRC.com

TLR Blog Update from JR Mitch:
www.losiracing.blogspot.com

Hello everyone,

This week I would like to share a little bumper mod on the TLR 22 4.0, 22 4.0 SR, 22T 3.0 line of vehicles. Sometimes trying to install the rear toe-in block with the bumper can be a little tough and this mod helps with that. Frist remove the material shown in the picture below. With this material removed you can install the toe-in block first using the center 2x6mm Flat Head Screw then sliding the bumper into its location and then installing the two 3x12mm Flat Head Screws securing everything together.

- JR

Photo Gallery

Gallery Photo: TLR 22 4.0 and 22T 3.0 rear bumper mod explained by JR Mitch

Share:

blog comments powered by Disqus

ADVERTISEMENT | ADVERTISE WITH US

ADVERTISEMENT | ADVERTISE WITH US