New Exotek Racing XXX-SCT 12mm front hub conversion, 22 3.0 alloy steering posts and 22-4 HD carbon fiber front shock tower

ADVERTISEMENT | ADVERTISE WITH US

By Aaron Waldron
LiveRC.com

New from Exotek Racing:
www.exotekracing.com

EXOTEK RACING XXX-SCT 12MM FRONT HEX/HUB CONVERSION
#1671, $50

Front 12mm hex axle and hub conversion for the Losi XXX-SCT.

The front conversion allows you to use the stock rear 12mm hex wheels on the front but also allows the mounting of Associated SC5M or Traxxas Slash front hex wheels (rear Slash wheels will make the SCT too wide) on all four corners of your XXX-SCT!

Choose from a wider selection of wheels thanks to our axle design.

Includes;

• 7075 alloy hubs for maximum durability.
• Trailing spindle design for improved drivability.
• Hard steel axle for max durability.
• 4 rubber sealed bearings.
• 4 2mm thick alloy spacers to allow you to widen the truck width as needed because different wheels have different off-sets.
• 2 ackerman positions.
• Instruction sheet and stickers.

NOTE wheels and approximate width dimensions;

• 286mm XXX-SCT wheels no spacers
• 290mm XXX-SCT wheels w/ spacers
• 289mm AE SC5M wheels w/ spacers
• 304mm Slash front wheels no spacers
• Losi 22SCT/ TEN-SCTE wheels will not work (makes the width extremely narrow).

EXOTEK RACING 22 3.0 ALLOY STEERING POSTS (2)
#1679, $9

Replacement alloy steering posts (2) for the 22 3.0/22T 2.0/22SCT 2.0.

Use with Exotek 22 3.0 Steering Set (#1580) to complete the parts needed to convert your 22 2.0, 22SCT 1.0 or 22T 1.0.

EXOTEK RACING 22-4 2.0/1.0 HD CARBON FIBER FRONT SHOCK TOWER, 5MM
#1680, $26

Extra heavy duty USA made 5mm quasi weave carbon fiber shock tower for the 22-4 2.0/1.0.

1 piece design insures maximum durability and suspension alignment.

Matches the stock geometry, except for the seldom used outermost hole which has been removed for better camber mount durability. Camber mount location also is reinforced with extra surrounding material and is thicker than stock. Because it is thicker, 2 longer TLR 8mm ball ends are required (not included).

2 countersunk holes with screws are used to make sure the tower stays square and aligned to the bulkhead.

2 alloy spacers are included to mount the front sway bar.