MIP Pucks™, 17.5 Drive System, X-Factory X-6³ (#14250, MSRP $100)
“MIP Pucks™” ‘ARE’ the future of 17.5 stock racing! MIP’s all new Puck™ Drive system is an aluminum based drivetrain system which includes aluminum diff outdrives, aluminum C-CVD™ bones, and replaceable plastic orange wear Pucks™ that take the place of inferior steel pins. This combination greatly increases the longevity of the drivetrain and most importantly decreases the drivetain’s overall rotating mass by nearly 50%! The decrease in weight directly results in quicker acceleration, deceleration, and lower motor temps! Get the advantage that every stock racer craves! GET, MIP’s all new Hard Anodized 7075-T6 Aluminum Puck™ drive system!
TARGET CUSTOMERS:
17.5 Stock Racers
COMPETITIVE ADVANTAGES:
Less rotating mass
Quicker acceleration
Quicker deceleration
Lower motor temps
Less overall wear on drive components.
FEATURES:
Complete MIP Differential
Complete C-CVD™ Axle Set
50% less rotating mass over stock steal components
Replaceable Pucks to keep your drivetrain fresh
Two sets of holes in the C-CVD™ bell
Hard Anodized 7075-T6 Aluminum
Race Proven C-CVD™ Construct
MIP Laser Etched Logo
100% Quality made in the USA!
INCLUDES:
MIP Confetti Sticker (2), MIP Thread Gel Safety Sheet (1), MIP Instruction Sheet (1), 3/32” Bearing Chrome Steel Ball (12), Diff Ring Washer (2), 1/16” Chrome Steel Ball Bearing (7), Hardened #2 Washer (1), MIP Thrust Retainer Washer (1), Diff Lube & Grease Cup (1), 52T Diff Gear (1), 1/4 x 9/32” Diff Spring (1), 5/32 x 5/16 x .125” Bearing (2), 2-56 x .925” Diff Shoulder Screw (1), Molded T-Nut (1), Diff Thrust Cover (1), MIP Pucks™ Male Outdrive (1), MIP Pucks™ Female Outdrive (1), SHSS 4-40 x 3/32” Cup Point (2), 8-32 Steel Locknut (2), 1/16” x .430” Solid Pin (2), 1/16” x 3/8” Roll Pin (2), 3/16” x .010” Steel Washer (4), 1-72 x 1/8” BHCS Screw (6), MIP 3/16” CVD™ Coupling (2), MIP CVD™ Axle (2), MIP Retaining Ring (2), MIP CVD™ Puck™ Pin (2), MIP Outdrive Pucks™ (8), MIP Pucks™ Alum. C-CVD™ Bone (2), MIP Lube & Thread Gel Cup (1)
REQUIRES:
.050 Allen Key – (Suggest - #9000 MIP Hex Driver Wrench .050 inch)
2.0mm Allen Key- (Suggest - #9008 MIP Hex Driver Wrench 2.0mm)
Eng / Usd
Français
Deutsch
Italiano
Recent comments