TLR machined 3-hole pistons for 22 series vehicles

0 April 24, 2015, 4:15 p.m.

By Aaron Waldron
LiveRC.com

Press release from Team Losi Racing:

www.tlracing.com

TLR is happy to announce the release of 3-Hole 12mm Machined Pistons! These pistons are offered in packs of 4, and with the hole diameters of 1.3mm and 1.4mm. The TLR race team has had great success running the prototypes of these pistons on their 22 2.0 and 22-4 buggies and have dabbled with them on their 22T 2.0 and 22SCT 2.0's also. Several key setups benefit from the reduced pack and quicker movement of the 3-Hole pistons, especially on tracks that are a little bumpier. See some of the key setup links below.

The part numbers are TLR233017 for the 3x1.3mm pistons, and the link to the TLR Site is here: http://www.tlracing.com/Search/Default.aspx?SearchTerm=TLR233017

The part numbers are TLR233018 for the 3x1.4mm pistons, and the link to the TLR Site is here: http://www.tlracing.com/Search/Default.aspx?SearchTerm=TLR233018

22 2.0 - Ryan Maifield Surf City Setup, 2014

22 2.0 - Ryan Maifield JC Fall Nats Setup, 2014

22 2.0 - Ryan Maifield Reedy Race Winning Setup, 2015

22 2.0 - Dustin Evans SC Showdown Setup for Slicks, 2014

Racer Tip - The popular 22-4 setups have all included the Split (2x1.4mm, 1x1.3mm) rear piston setup. With the new 3x1.3mm pistons, there is now an easier way to get to this setup. Just take a 3x1.3mm piston and drill out the two holes with a 1.4mm drill bit, and you're done. A lot less work and now no need for a 1.3mm drill bit either. Check out those setups below.

22-4 - Ryan Maifield Reedy Race Winning Setup, 2015

22-4 - Ryan Maifield Surf City Setup, 2014

We hope you enjoy these pistons as much as the team has! :)

Race On!

Share: