ADVERTISEMENT | ADVERTISE WITH US
0
Feb. 2, 2015, 7:01 a.m.
2/2/2015
By Aaron Waldron
LiveRC.com
New from MIP:
Rear Motor or Mid Motor for stock racing? This question is debated among racers as it is a tossup of whether to have more corner speed (mid motor) or less drag / more initial punch (rear motor). Now the next question arises, why can’t we have both? The answer is the MIP BOX! This new 7075 Aluminum 3-gear transmission for the Team Associated B5M bridges that gap and gives your mid motor buggy all the benefits of the rear motor car but less drag and more initial punch. Not only does the BOX eliminate one idler gear to equate to less drag but it’s all aluminum construct offers a huge advantage pertaining to more precise internal gear mesh, less overall heat, and stiffer bracing. Check out all the competitive advantages below to solidify why the BOX is the ultimate 3-gear transmission for your AE B5M!
Race Proven
- TQ/1st CRCRC Midwest Champs 2015 Stock Buggy
- TQ/1st JC Nationals RC Excitement 2014
TARGET CUSTOMERS:
Team Associated B5M Owners
COMPETITIVE ADVANTAGES:
- Machined cases offer higher precision which optimizes gear mesh and efficiency when compared to molded plastic cases
- Aluminum construct acts as a giant heat sink which will cool the motor offering more consistent power due to reduced fade (less heat more power).
- Aluminum construct will offer stiffer bracing over plastic OEM case.
- Aluminum 3-gear MIP Transmission package is relatively the same overall weight as OEM 4-gear transmission. This will keep the weight distribution the same as what the car was designed to have. (MIP BOX 5.5 grams heavier)
- Motor offset 3mm to the right to optimize left to right weight distribution and balance (small spacer and new spring provided to accommodate this feature)
- Less drag than a four gear transmission design (one less idler gear).
- 50% Lighter gear cover over stock
- 7075 Aluminum
- Made 100% in the USA
#14300 MIP BOX, AE B5M Trans
MSRP: $150.00
Eng / Usd
Français
Deutsch
Italiano
Recent comments