New Avid RC 5.5x6mm Titanium Ball Stud -1mm

Press Release From Avid RC:
www.avidrc.com

The 5.5x6mm -1mm Titanium Ball Studs lower the ball 1mm to offer racers some fine tuning adjustability in all modern AE 10th offroad vehicles. For example, on the B7 you can run these in three key locations (steering plate to adjust bump steer, steering rack to adjust Ackermann, and *front inner camber link on the outside to adjust roll center/camber gain).

Tips

• *Front inner camber link mount: You can run these on the outer position of the front bulkhead without the rod end hitting it at full droop. But in order to run the middle hole on the bulkhead you will need to trim the outer edge of the bulkhead to get clearance. We have found on the B7 when running the B6.4 steering on carpet, you will want to run these so you will be into the camber gain at 13mm ride height.
• It is recommended to use all new plastics when switching ball stud brands but isn't necessary. Just be cautious when installing to make sure you don't over-tighten them.

Features

• The ball is lowered 1mm from the kit AE ball stud heights (check additional images, the kit ball stud is on the left and the -1mm on the right).
• Machined from billet 6Al-4V Titanium.
• Broached with a 2mm allen head on top of the ball for easy removal.
• 40% lighter than the kit and optional TiN coated steel ball studs.
• These will work on all the modern AE 10th scale offroad vehicles.
• Each package includes (2) 5.5x6mm Titanium Ball Studs, and 1 AVID mini decal sheet.