New Bittydesign P-GT3R USGT Body

Press Release From Bittydesign:
www.bittydesign.net/en/

The Bittydesign P-GT3R body shell is universal and mounts on all 1/10 190mm models, the wing complies with the measures as per USGT regulation (10mm height) and can therefore be used at any race.

>> Made with high quality and genuine polycarbonate Lexan®

>> Fits all the 190mm electric chassis on the market with 258-260mm wheelbase

>> Included in the kit a complete set of screw, nuts and large plastic washers to fix properly the rear wing

>> Included the front nose flaps (to be mounted with double side tape; mounting is not mandatory, upon user choice)

>> Included in the package a decal sheet pre-cut and windows mask

>> Sold clear with protective film outside

The shapes inspired by a GT3 racing car have been adapted to the proportions and measures necessary for use with the 190mm electric models; the design phase took several months to finish every single particular, the attention to detail was obsessive in order to propose a body that could optimize aerodynamics and at the same time remain real in its proportions and aesthetics.