ADVERTISEMENT | ADVERTISE WITH US
ADVERTISEMENT | ADVERTISE WITH US
By Tyler Hooks
LiveRC.com
Press Release from Darkside Designs:
www.darksidedesigns.net
B6.1 molded wing savers.
Snaps over factory wing mounts to help prevent bent mounts. Have been track tested all summer with great success in saving wing mounts. Dot marks forward position of saver. Molded not 3d printed.
Diff build & check tool.
Cut in house out of 2mm carbon. Has two posts to set diff halves on while building. After completion the diff can be slid down the center so you can use your thumb to turn the gear to check tightness.
ADVERTISEMENT | ADVERTISE WITH US
ADVERTISEMENT | ADVERTISE WITH US
Recent comments