LiveRC Menu

ADVERTISEMENT | ADVERTISE WITH US

New Team Associated B74.1/2 Vertical Rear Ballstud Mounts

New Products

ADVERTISEMENT | ADVERTISE WITH US


92323.ps_lg.jpg

Press Release From Factory Team:
www.associatedelectrics.com/factoryteam/

New from Factory Team are Vertical Ballstud Mounts for the RC10B74 series cars. These vertical ballstud mounts increase the tunability of the rear camber link, allowing for lower ballstud positions to be used as well as a further outward ballstud position. These pieces mount directly to the tower included in the RC10B74.1 kit. See below for details regarding mounting and setup capabilities.

The intent of these mounts is to allow drivers more versatility than what is available on the kit tower, particularly regarding mounting the inner rear ballstud, which affects the roll center and camber gain of the car. The extent of the available adjustment range will depend on multiple factors such as differential height, hub height, link length, and more.

The chart below shows the number of washers needed above the ballstud to match the vertical height of the positions available on the kit tower. N/A indicates positions that cannot be achieved with the Vertical Ballstud Mounts installed.

{{block.title}}
blog comments powered by Disqus

ADVERTISEMENT | ADVERTISE WITH US

About the Author

Tyler Hooks is a recent college graduate with a BBA in management and a Minor in Communications from St. Edwards University as well as a ROAR Stock National Champion and was apart of the IFMAR World Championship USA team in 2016. Tyler is currently an Editor as well as in the Advertising department at Live Race Media and frequently is apart of the broadcast team at major events.

Recent comments

ADVERTISEMENT | ADVERTISE WITH US