LiveRC Menu

ADVERTISEMENT | ADVERTISE WITH US

New Team Associated FT Gear Mesh Inserts and Dog Bones

New Products

ADVERTISEMENT | ADVERTISE WITH US


unnamed.jpg

Press Release From Team Associated:
www.associatedelectrics.com

Factory Team Gear Mesh Inserts are used for quickly setting the gear mesh on the RC8B3 or RC8T3 nitro platforms. Especially useful on the stock 2-piece motor mount, they can also be used on the FT 3-piece mount to set gear mesh with proper teeth alignment. The inserts are compatible with 13T and 14T clutch bells without any changes to the insert orientation.

Installation is as easy as replacing the stock motor mount washers with these new pieces. It is recommended to start with a new spur gear and new clutch bell to ensure even wear of the gear teeth.

Made specifically for OS based engines, these inserts also work well with other .21 sized engines. Compatible with: RC8B3, RC8B3.1, RC8B3.2, RC8T3, RC8T3.1, RC8T3.2

Upgrade the center drive line with new dogbone sets for the RC8B3 series buggies (front and rear) and RC8T3 series (front only)! Dogbones will increase the efficiency and life of your center drive line over universals because of the simplified drive system with only one drive pin instead of two (universal joint).

Note during installation that the shorter length 3x12mm pin goes into the center diff while the larger 3x14mm pin goes into the front or rear outdrive. Each set contains one dogbone, one outdrive, and one M5x4mm set screw

Fits: RC8B3, RC8B3e, RC8B3.1, RC8B3.1e, RC8B3.2, and RC8B3.2e.

#81466 front set will also fit the RC8T3, RC8T3e, RC8T3.1, RC8T3.1e, RC8T3.2, and RC8T3.2e. #81467 rear

set will not fit due to chassis length.

{{block.title}}
blog comments powered by Disqus

ADVERTISEMENT | ADVERTISE WITH US

About the Author

Tyler Hooks is a recent college graduate with a BBA in management and a Minor in Communications from St. Edwards University as well as a ROAR Stock National Champion and was apart of the IFMAR World Championship USA team in 2016. Tyler is currently an Editor as well as in the Advertising department at Live Race Media and frequently is apart of the broadcast team at major events.

Recent comments

ADVERTISEMENT | ADVERTISE WITH US