New Tekno RC EB410/ET410 sway bar sets

ADVERTISEMENT | ADVERTISE WITH US

Mike Garrison

0 May 30, 2018, 11:05 a.m.

By Mike Garrison
LiveRC.com

Press Release from Tekno RC:
www.teknorc.com

Tekno RC is proud to announce two new sway bar sets for the EB410 1/10th scale 4wd buggy. It is now easier than ever to fine-tune your setup depending on the traction level, from loamy low traction surfaces to high grip carpet Tekno RC has you covered! Links and more information regarding each set below:

TKR6611 - Sway Bar Set (rear, bars only, 1.0, 1.1, 1.2, 1.3, 1.4mm, EB410/ET410)

Use these optional sway bars to tune the roll characteristics of your EB410 and ET410.  This set of rear sway bars are thinner than the stock sway bars on the EB/ET410 and are a useful option for low grip surfaces.  They will help generate additional rear traction and can also aid in stabilizing the rear suspension on very bumpy surfaces.

Includes
1x each of the following: 1.0mm, 1.1mm, 1.2mm, 1.3mm, 1.4mm rear sway bars.

TKR6624 - Sway Bar Set (front, bars only, 1.5, 1.6, 1.7, 1.8, 1.9mm, EB410/ET410)

Use these optional sway bars to tune the roll characteristics of your EB410 and ET410. This set of front sway bars are thicker than those found in TKR6623 and are best used on higher grip surfaces such as carpet or blue grooved clay.  They provide a great tuning option to reduce steering sensitivity and prevent traction rolling on high bite surfaces.

Includes
1x each of the following: 1.5mm, 1.6mm, 1.7mm, 1.8mm, 1.9mm front sway bars.