New WellCut 1/8 Front Body Post and Exhaust Outlet Magnetic Marking Tools

ADVERTISEMENT | ADVERTISE WITH US

Mike Garrison

0 Nov. 18, 2019, 1:40 p.m.

By Mike Garrison
LiveRC.com

Press Release from 1upRacing:
www.1upracing.com

WellCut for 1/8 Front Body Posts

Place the WellCuts over the front body posts with the magnets facing the rear of the car and secure them with 2 body clips.  After using the WellCut Template to cut out the rear of the car, set the body on the car and drop the front 2 outer magnets into place.  The super strong magnets will immediately center themselves!  Use a fine tip black permanent marker to mark the centers of the magnets.  Remove the body and cut the 2 holes with a body reamer and you're set!  The WellCut for 1/8 Front Body posts is a must have in any 1/8 nitro racer's tool box!  Available in 2 sizes to fit 7 and 8mm diameter front posts!

WellCut for Exhaust Outlet

Cut the perfect hole for your exhaust stinger every time with the WellCut for Exhaust Outlet!  Just slide the WellCut into place and align it so the outer edge sits parallel against the body.  Drop the included outer magnet into place and use a fine tip permanent marker to mark the center hole.  Use a body reamer to cut the hole and enjoy perfect results time after time!  Universal size fits most 1/10 and 1/8 exhaust stingers!

The WellRC products can be found at https://1upracing.com/brand/wellrc/