ADVERTISEMENT | ADVERTISE WITH US
0
April 19, 2012, 4:29 a.m.
4/19/2012
By Mike Garrison
LiveRC.com
Following the race report from the 4th round of ETS in Poznan, Poland you can now get an insight view on the winning car of Alex. Check out what all standard and option parts Alex used to dominate the ETS race, all these parts are standardly available to everyone (except the soon to be released progressive springs). Anyone can use and have the same set-up of the car as the factory team. Check out also the
set-up sheet from Alex.
Hagberg's setup uses the following option parts:
#293501 Alu Servo Horn - KO, JR, Sanwa, Airtronics - 23T
#301133 T3'12 Graphite Chassis 2.0mm
#302048-O T3 Alu Lower Rear Suspension 1-Piece Holder - Orange
#302167 Comp. Front Susp. Arm 1-Hole - Graphite
#303167 Comp. Rear Susp. Arm 1-Hole - Graphite
#302373 Composite C-Hub Right - 4° Deg. - Hard
#302374 Composite C-Hub Left - 4° Deg. - Hard
#303440 Alu Anti-Roll Bar Collar (2)
#303484 Anti-Roll Bar Rear 1.4mm
#305327 Equalized Corner Speed (ECS) Drive Shaft 52mm - Hudy Spring Steel™ (1)
#305328 Alu Drive Shaft Swiss 7075 T6 - Hard Coated - 50mm
#305392 Drive Shaft Pin 2x10 with Flat Spot (2)
#308031-O Alu XRAY Shock Spring Retaining Collar - Orange (4)
#308306-O XRAY Alu Shock Absorber - Set - Orange (2)
#308374 XRAY Spring-Set C = 2.4 (2)
Eng / Usd
Français
Deutsch
Italiano
Recent comments